RobotDogg Community

Motor n Driver

Stepper Motor, Stepper Driver, Servo Motor n Controller

Instructions for Syringe SM-X2001A-3A-OL ? - Help
- Motor n Driver
- SteveR_442 started 2021-05-13 20:33
- Where can I locate instructions (English preferred) , for the Syringe (SM-X2001A-3A-OL) ?This is the stepper motor with a screw drive and controller attached to the motor end.It has a pot, silve...
0
Back drivable linear ball screw actuators
- Motor n Driver
- robotdigg replied 2018-04-09 02:02
- I am trying to find back drivable linear ball screw Actuators. I would like to use a push force of about 20 - 40 Newton’s to push and pull the actuator with the motor off (not powered). With the m...
1
Stepper motor holding ability?
- Motor n Driver
- robotdigg replied 2018-04-04 06:34
- I have a desktop engraver that has the Nema 17 stepper motors. I have set up the controllers with about 1.5 amps, and it does OK. The Z axis is using a dremel for my engraver. The problem is the holdi...
1
Questions about part #BJXL100
- Motor n Driver
- robotdigg replied 2018-04-03 02:04
- https://www.robotdigg.com/product/1270/9-36V-DC-stepper-motor-linear-actuatorI would like to order the 250N, 100mm, 12mm/s product. First, how do I order the 250N product instead of the 50...
2
Stepper Drive Timing
- Motor n Driver
- Derek Meng started 2016-09-03 08:58
- http://www.robotdigg.com/product/615http://www.robotdigg.com/product/569 DM442? http://wiki.linuxcnc.org/cgi-bin/wiki.pl?Stepper_Drive_Timing
0